Helos Cat 6a S/FTP PIMF Ethernet patch kábel, zöld, 2 m

helos Cat 6a Ethernet patch cable, S/FTP PIMF shielding, 2 m long in green, designed for high-speed structured cabling and point-to-point connections. The cable supports Category 6a performance and is suitable for 10 Gbps Ethernet over compatible infrastructure. S/FTP PIMF (shielded/foiled twisted pair with overall braid and individually foil-wrapped pairs) reduces electromagnetic interference and crosstalk, improving signal integrity in environments with multiple cables and active equipment.

Advantages

The helos Cat 6a patch cable offers enhanced shielding with S/FTP PIMF construction to limit external interference and pair-to-pair crosstalk. At 2 meters length and with standard RJ45 terminations, it provides reliable connectivity for switches, patch panels and active network devices. The green jacket allows easy visual identification in cable runs and rack installations. The cable conforms to Cat 6a performance parameters to support higher bandwidth and lower near-end crosstalk compared with lower category cables.

Suitable for

• Connecting switches, routers and patch panels in offices and data closets
• Workstation connections where 10 Gbps or high-speed links are required over short distances
• Environments with potential electromagnetic interference where shielded cabling is preferred
• Organized color-coded cabling installations and home network setups

Key specifications

• Category: Cat 6a performance
• Shielding: S/FTP PIMF (overall braid + foil-wrapped individual pairs)
• Length: 2 meters
• Connector type: RJ45 terminated at both ends
• Color: Green jacket for visual identification
• Supported data rate: up to 10 Gbps over compatible infrastructure
• Recommended frequency range: supports up to 500 MHz performance typical for Cat 6a

How to use

Install the helos Cat 6a patch cable by inserting the RJ45 plug into the corresponding port on the network device or patch panel until the latch clicks. Use the 2 m length for short links between racks, switches and wall outlets or for connecting devices on or near workstations. Ensure connectors are fully seated and avoid tight bends or kinks near the termination points. When used in shielded installations, verify that connected equipment and patch panels provide proper grounding to benefit from the S/FTP PIMF shielding.

Recommendations

For optimal performance, keep patch cable runs within recommended lengths for copper Ethernet and avoid coiling or compressing the cable. In shielded systems, maintain continuous grounding and use shielded connectors and panels. Use the green cable for consistent color-coding in multi-cable deployments to simplify identification and maintenance.