Hőre zsugorodó cső CellPack 144413, 100 cm hosszú, egyes csomagolás

CellPack 144413 is a 100 cm heat shrink tubing supplied as a single-piece roll for electrical insulation and cable repair. The thin-wall tube is designed to provide mechanical protection and improved insulation for wires, joints and connectors in household, automotive and electronics applications. The material is UV stabilized, resistant to chemical agents and maintains high flexibility and tensile strength while offering superior electrical properties and thermal stability.

Advantages

The heat shrink tubing offers thin-wall construction without thermoplastic adhesive, making it suitable where adhesive-lined tubing is not required. It is inscribable for marking, non-corrosive and free from paint-wetting inhibiting substances. The tubing is resistant to cold flow and chemical agents, stabilized against UV rays, and provides self-extinguishing behavior for opaque colours. Its high tensile strength and flexibility ensure reliable mechanical protection of cables and components.

Suitable for

• Insulation of wire splices and soldered joints
• Protection of connector ends and terminal blocks
• Repair and reinforcement of damaged cable jackets
• Identification and marking of wiring runs after inscription
• Electronics assemblies requiring thin-wall protective tubing

Key specifications

• Material type: thin-wall heat shrink tubing (non-adhesive)
• Length: 100 cm (single piece)
• Wall: thin
• Adhesive: without thermoplastic adhesive
• Marking: inscribable surface
• Chemical resistance: resistant to chemical agents
• UV resistance: stabilized against UV rays
• Flammability: self-extinguishing for opaque variants
• Mechanical properties: high flexibility and high tensile strength
• Thermal properties: resistant to cold flow / thermally stable
• Compatibility: non-corrosive and free from paint-wetting inhibiting substances

How to use

Select an appropriate diameter for the cable or joint so the tubing will shrink to provide a snug fit. Slide the tubing over the wire, splice or connector before making the final connection where applicable, then apply heat evenly along the length using a heat gun, hot-air tool or appropriate heat source until the tubing conforms tightly to the underlying component. Allow to cool to ensure full recovery and mechanical stability. For identification, mark the tubing before installation if required.

Recommendations

When applying heat shrink tubing, use a regulated heat source to avoid overheating adjacent components and ensure uniform shrinkage. For outdoor or UV-exposed installations, choose an opaque, UV-stabilized section of the tubing. If increased environmental sealing is needed, consider a suitable adhesive-lined heat shrink alternative. Store the roll away from direct sunlight and high temperatures to preserve material properties.