Fiók Kapcsolat
Kosár
DPD & FedEx – a várható kiszállítás dátuma a termékoldalon.
Segítségre van szüksége? Kérdezze AI-asszisztensünket!

Steca Solsum 8.8F 8A PWM napelemes töltésvezérlő, 12 V/24 V

Steca Solsum 8.8F 8A PWM napelemes töltésvezérlő, 12 V/24 V
Steca Solsum 8.8F 8A PWM napelemes töltésvezérlő, 12 V/24 V
14 131 Ft
PDF
PDF
Készlet 10 Termékkód 4528309 Modell 321715 Garancia 2 év

Szállítás és visszaküldés

Várható kiszállítás november 27., péntek
Részletes csomagkövető rendszerünk segítségével folyamatosan tájékoztatjuk
Fizetési lehetőségek
BankkártyaVisaMastercardPayPalApple PayGoogle PayBanki átutalás

Leírás

The Steca Solsum 8.8F is a PWM solar charge controller for smaller 12 V and 24 V photovoltaic systems with up to 8 A charge and load current.

8 A charge and load current for appropriately sized small photovoltaic systems

  • Automatic detection of 12 V or 24 V system voltage
  • PWM charge control with multi-stage charging technology

It controls the charging of the connected battery, manages the load output, and protects the system against overcharging, deep discharge, short circuit, and reverse polarity. Automatic system voltage detection and LED indicators for operating status and battery status simplify commissioning and ongoing monitoring.

PWM solar charge controller with 8 A for compact 12 V and 24 V systems

Integrated deep discharge protection with automatic load disconnect and reconnect

Temperature-compensated charging to adjust charging voltage to ambient temperature

LED indicators for operating status, battery state of charge, and fault diagnosis

  • Comprehensive electronic protection functions
  • Low self-consumption of less than 4 mA
  • Designed for indoor use and rated IP32
  • PWM charge control and battery management

The controller operates using PWM (pulse width modulation). The charging current from the solar module is regulated so that the battery is charged in a controlled manner and protected against overcharging. Unlike an MPPT controller, there is no active conversion of the module voltage to optimize the operating point. The Solsum is therefore particularly suitable for smaller, appropriately sized solar systems where a simple PWM charge controller is intended. In addition to charge regulation, the device monitors the battery state of charge and controls a separate load output. If the battery voltage or state of charge drops too low, the controller automatically disconnects connected loads. After sufficient recharging, the output is automatically reactivated. This reduces harmful deep discharge of the battery. Charge regulation also includes voltage regulation, temperature compensation, and a monthly maintenance charge. The controller automatically adapts to a 12 V or 24 V system.

  • LED display for operating status and battery

The front has several LEDs that provide important system information directly on the controller. The info LED signals normal operation or various fault conditions. A multi-colour battery indicator shows the state of charge of the battery, while the red LED indicates, among other things, an active deep discharge disconnect.

  • Protection of battery, solar module, and loads

The solar charge controller has various electronic protection mechanisms for typical fault conditions in small off-grid systems. These include overcharge and deep discharge protection, reverse polarity protection for solar module, battery, and loads, as well as short circuit protection on module and load. Additionally, night-time reverse current protection, open circuit protection when battery is missing, an automatic electronic fuse, and protection against overtemperature, overload, and battery overvoltage are integrated. However, these functions do not replace correct electrical design and installation of the system.

  • Battery type and important selection notes

The Steca Solsum series is factory-set for AGM or GEL batteries. If a flooded lead-acid battery is to be used, the battery configuration must be changed accordingly. For this, the optional Steca PA RC10 remote control or a corresponding configuration before delivery is provided.

  • Installation and connection

The controller is intended for vertical wall mounting on a solid, flat, non-combustible surface. The installation location should be dry and protected from direct sunlight.

Műszaki adatok

Műszaki adatok
Alkalmazási terület
indoor
Áramerősség
8 A
EAN
4250852802208
Elem feszültsége
12 V / 24 V
Gyártói cikkszám (MPN)
321715
Kategória
Napelemes töltésvezérlők
LED-jelzők
Igen
Márka
Steca
Modell
321715
Terméktípus
PWM solar charge controller
Töltőáram
8 A
Tömeg
150 g
Üzemi hőmérséklet-tartomány
-25 °C to +50 °C
Védettségi fokozat (IP)
IP32
Az elmúlt 6 hónap ártörténete
Steca Solsum 8.8F 8A PWM napelemes töltésvezérlő, 12 V/24 V
Jelenlegi
14 131 Ft
Legalacsonyabb 7 nap
14 131 Ft
Legmagasabb 7 nap
14 180 Ft
24 órás változás
-48 Ft   0%
7 napos változás
—   
30 napos változás
—   

Értékelés írása

Értékelés *
Megjegyzés: A HTML-formázás nem jelenik meg!

További STECA termékek ebben a kategóriában

9

Népszerű termékek ebben a kategóriában

8
Eladó: UAB KUR LT · Gariūnų g. 57-14, LT-02300 Vilnius, Litvánia · Cégjegyzékszám 303192950 · Közösségi adószám LT100008198612 · Szállítás az EU-ból (Litvánia)
WhatsApp
Messenger
Üdvözlöm, a DistriNode AI-asszisztense vagyok. Szívesen segítek termékek keresésében, a lehetőségek összehasonlításában, PDF-árajánlatok készítésében vagy ügyfélszolgálati bejelentések indításában.
Összes kategória